Laser Cutting and Engraving

We can help you make your mark.

Comments are closed.

  • Tools and Talent.

    At Superfab, we've got two fine lasers to put to work for you.   These 25 & 50 watt machines can cut through material up to 1/4" thick, 18" x 32".    We can even engrave in the round!   Lasers abound these days, but we boast in-house talent with 12 years of experience  (think 2002!) with this work.   With that, you can trust we'll get the job done fabulously.

    Less Costly than you Think.

    In most cases, we handle job setup and machining time at a rate of $95/hr, with a minimum 1/2 hour each.   While we do jobs both big and small, the smaller ones are are always billed on a time and materials basis.   In these cases, we'll give you a ranged estimate of the likely cost on the front end and some tips on how to keep the billable time down.    If you'd like to see what we think it will take, just drop us a line.   We'll get back to you right quick.   

    Re: Files

    We can work with a wide variety of file types, but the most common are .dwg or simple .pdf files.   When it comes to creating a file, If you need a hand, no sweat!   Our digital drawing skills are here for you, too.
  • 971.312.6991 1875 SE Belmont, Portland, Oregon 97214 © 2015 SuperFab